RING BINDER
Are you selling this ring binder? The ring binder is a form of mechanical binding similar to the
ring notebook paper binder, only much larger. This type of binder has declined in popularity in recent
times because it is prone to accidental opening, and, in addition, the bulk of the spine is large in
proportion to the quantity of paper it can hold.
Ring binders are folders in which punched pieces of paper may be held by means of clamps or rods running
through holes in the paper. These retainers are usually spring-loaded, frequently but not invariably circular,
and may or may not have additional latching systems.
For the purpose of this Regulation, ring binder mechanisms shall consist of two rectangular steel sheets
or wires with at least four half rings made of steel wire fixed on it and which are kept together by a
steel cover. They can be opened either by pulling the half rings or with a small steel-made trigger
mechanism fixed to the ring binder mechanism.
The Ring Binder allows for totally modular presentations with the ability to add, and take out, or replace
individual page-protectors. A device to be removably attached to an openable side of a ring binder, said
ring binder having two covers and a spine with a paperlock secured to said spine, said device having sufficient
length to protect material contained within said ring binder and said device having sufficient width to render
said covers substantially flat.
The special 3-ring provides the organizational capabilities of a binder while the box enclosure provides much
greater protection from dust, dirt and other pollutants than does a standard ring binder.
We bet you never knew there could be so much in choosing a leather binder! Take a look and we are sure you will
find the leather binder you have been searching for! Each binder is electronically sealed over a rigid board
and provides a long life and exceptional durability.
This binder box was designed for a customer who needed the convenience of our hand-made cloth-covered ring
binder coupled with the economy offered by production fabrication. These sleeves may be easily punched
for a standard 3-ring binder using any paper drill punch.
D-Ring binders allow your looseleaf pages to lie flat whether the binder is open or closed and are
especially recommended on larger sizes that are used frequently. Binder is clearview type with a clear
plastic sleeve on front, back and left side.
D-Ring binders allow pages to lie flat whether the binder is open or closed. And because the ring mechanism
is riveted to the back cover, artwork on the spine is not interrupted by rivets. They are pieces of rigid
plastic that prevent pages from curling around the ring mechanism in a binder.
The binder selected for each report will generally depend upon the quantity of paper which but must be bound.
If the report is under a few hundred pages, a standard-duty three ring binder is sufficient.
The binder is designed with a five ring binding system adding to the product's durability when the weight
increases due to disc insertion. The three-ring binder is the most effective tool for students to organize
and maintain information for processing. Material can be added, deleted, and placed in proper sequence with
a three-ring binder.
|
